Flying Whale H45-10 Solvent-free Epoxy Drinking Tank Paint

With epoxy resin and polyamine adduct as the base material of two-component solvent-free, thick paste type pure epoxy paint, paint film has excellent water resistance, salt water resistance, rust resistance and good mechanical properties, after drying non-toxic, tasteless, in line with the relevant provisions of the "drinking water health standards.

It is suitable for the inner wall of drinking water tank, distilled water tank, pipe lining, granary, beer tank and other kinds of drinking water and food containers for protection and anti-corrosion coating. You can also use empty spaces, compartments, and wet areas.

Note: 1. The above data are for reference only. The actual drying time and the length of the re-coating interval depend on the film thickness, ventilation, humidity, lower paint and mechanical strength, etc.

2. The surface of the paint film before recoating must be clean and dry, free of pulverization and other pollutants. If necessary, the surface before recoating should be fully napped.

The substrate temperature shall be at least 3 ℃ higher than the air dew point, and the relative humidity shall be lower than 85%. The measurement of temperature and humidity should be carried out at the substrate near the operation point. When the construction is not in an open space, good ventilation must be provided to ensure the normal drying of the paint film.

All surfaces to be coated shall be clean, dry and free of contaminants.
Newbuilding/Overhaul: Remove weld spatter and polish welds and sharp edges at surfaces to be painted, grit blasted to Sa2.5 or power tool to St3. The shop primer shall be cleaned by abrasive blasting to class Sa2.5. For areas that have been blasted, primer shall be applied before oxidation occurs, and if oxidation does occur, re-blasted.
Repair: The surface of the damaged area shall be sandblasted to Grade Sa2.5 or treated with power tools to Grade St3. For the sandblasted area, primer shall be applied before oxidation occurs. If oxidation does occur, the entire oxidized area shall be sandblasted again.

For more scope of use, please consult Flying Whale New Material Company.

Before using this product, please pay attention to the safety label on the packaging container, refer to and follow the information and precautions related to health and safety in the product safety technical manual of flying whale new material company. During the construction and drying of the product, appropriate ventilation and preventive measures must be adopted to control the solvent concentration within the safety limit to prevent poisoning or hypoxia. Take measures to avoid skin and eye contact with the product. If contact occurs, wash it immediately with suitable detergent, soap and water. If splashed into eyes, rinse with water and seek medical treatment immediately.

Store in a cool, dry, ventilated and dedicated warehouse away from heat sources. Under normal temperature conditions, the storage period is 12 months, and then it needs to be used after passing the inspection.

This product will not be fully cured below 10 ℃. In order to achieve the best performance, the curing environment temperature should be higher than 15 ℃.
The paint film before the contents of the drinking water container coated with this product should be completely cured and soaked and cleaned with sufficient drinking water. The specific cleaning procedure can be consulted from Flying Whale Company.

The above information and data of this product are accumulated according to our test and actual use experience, which can be used as a construction guide. For the construction carried out without our knowledge, we only guarantee the quality of the paint itself and are not responsible for any product performance problems arising from other aspects. We have the right to modify this manual according to the continuous improvement of the product.

Film thickness and coating rate