Flying Whale High Solid Epoxy Glass Flake Paint 680

Two-component ultra-high solid content polyamine adduct cured epoxy glass flake.

At the same time, it can be applied to offshore equipment and onshore facilities. It is specially designed for industrial heavy anti-corrosion and other harsh corrosive environments. The glass flake strengthening technology can effectively improve the impact resistance and wear resistance of the coating. It has excellent anti-cracking performance, sea water resistance and anti-corrosion performance. The single coating completed by one coating can achieve long-term protection effect and can be compatible with well-designed cathodic protection system, it has strong adhesion in a variety of surface states, and can also be applied to wet sandblasted substrates (whether the surface is dry or wet).

Note: 1. The above data are for reference only. The actual drying time and the length of the re-coating interval depend on the film thickness, ventilation, humidity, lower paint and mechanical strength, etc.

2. The surface of the paint film before recoating must be clean and dry, free of pulverization and other pollutants. If necessary, the surface before recoating should be fully napped.

During the coating process and coating curing process, ensure that the substrate temperature is higher than 0°C (32 °F), and the surface temperature of the substrate during the coating process should be at least 3°C (5 °F) higher than the dew point temperature.

The performance and quality of the coating depend on the quality grade of the surface treatment. Bare steel: sand blasting meets the ISO-8501-1 Sa2 or Sa2 ½ of the international standard. The surface roughness after sand blasting is recommended to be controlled at 40-80 microns. High-pressure water jet cleaning meets the WJ2/3 L of SSPC-VIS 4 standard. Wheel pieces polished to St3; Primer steel coated in workshop: slightly sweep sand or use elastic grinding wheel to polish the corroded part to Grade St3; For welding, flame cutting or burning parts: after removing welding slag and spatter, polish them with elastic grinding wheel to Grade St3 to determine the pre-coating compatible with them: the surface must be clean and dry, and all pollutants have been removed.

For more scope of use, please consult Flying Whale New Material Company.

Before using this product, please pay attention to the safety label on the packaging container, refer to and follow the information and precautions related to health and safety in the product safety technical manual of flying whale new material company. During the construction and drying of the product, appropriate ventilation and preventive measures must be adopted to control the solvent concentration within the safety limit to prevent poisoning or hypoxia. Take measures to avoid skin and eye contact with the product. If contact occurs, wash it immediately with suitable detergent, soap and water. If splashed into eyes, rinse with water and seek medical treatment immediately.

Store in a cool, dry, ventilated and dedicated warehouse away from heat sources. Under normal temperature conditions, the storage period is 12 months, and then it needs to be used after passing the inspection.

The above information and data of this product are accumulated according to our test and actual use experience, which can be used as a construction guide. For the construction carried out without our knowledge, we only guarantee the quality of the paint itself and are not responsible for any product performance problems arising from other aspects. We have the right to modify this manual according to the continuous improvement of the product.

Theoretical coating rate

Coating interval of coating(@ 600 microns)

Note: Make sure that the surface is clean, dry and all contaminants have been removed before coating.

Coating Cure Schedule @ 600Micron

Remarks:

-For dark coatings in tidal areas such as dams and piles, if the coating is prematurely submerged in water in the undried state after completion, it may appear that the surface is white, but it will not substantially affect the final corrosion resistance of the coating.

-Continuous and smooth adequate ventilation must be ensured during the application and curing of the coating.

Use time after mixing(at suitable construction viscosity)